Rockford Fosgate T1000-1bdCP Power Series mono sub amplifier 1.000 watts RMS x 1 at 2 ohms

Powerful bass performance Rockford Fosgate enjoys a well-deserved reputation for building high-quality mobile audio products. Their Power Series amps sit at the top of the car audio food chain. with proven durability and proprietary technologies that deliver stronger. more reliable performance than most other amps on the planet today. Rockford Fosgate’s high-tech solutions yield more power. Power Series amplifiers actively monitor their speakers’ performance using Rockford Fosgate’s Constant Power technology. A speaker’s impedance naturally fluctuates as it performs. So. just like your cruise control increases the engine’s RPM to maintain your car’s speed uphill. Constant Power maintains this amp’s output by increasing its internal voltage and current when the speaker’s impedance rises. This results in up to a 25 percent increase in the amp’s total power output. especially in the crucial range below 50 Hz where a sub amp really has to shine. Rugged construction. massive bass. Rockford Fosgate builds each Power Series mono amplifier with heavy-duty. state-of-the-art components. The award-winning Dynamic Thermal Management design manages the temperature of the internal components. distributing heat evenly for higher efficiency and lower distortion. The unique heat sink allows the heat to escape more readily so the high-power output transistors stay cooler and last longer. The T1000-1bdCP mono sub amp uses an efficient Class bd design to deliver up to 1.000 watts to your subwoofer system from a remarkably compact chassis. This amp can even drive a 1-ohm load. so you can get massive bass out of a wide variety of system design.

• 700 watts RMS x 1 at 4 ohms (1.000 watts RMS x 1 at 2 ohms)
• 1.000 watts RMS x 1 at 1 ohm
• CEA-2006 compliant
• Variable low-pass filter (35-250 Hz. 24 dB/octave)
• Selectable subsonic filter (28Hz. 24 dB/octave)
• Variable bass boost (0-18 dB at 45 Hz)
• Optional wired remote bass boost
• MOSFET power and output stages
• Preamp-level inputs
• Preamp outputs
• 4-gauge power and ground leads and a 150-amp fuse recommended
• Wiring and hardware not included with the amplifier
• No onboard fuses – When installing multiple amps in a system. an additional 150-amp in-line fuse between the distribution block and the amplifier is recommended
• 13-11/16 W x 2-1/4 H x 8-15/16 D
• Warranty: 2 years