Alphasonik NA1600.1AB Neuron Series Class A/B Monoblock 1600 Watts 4 Ohms Car Amplifier

Alphasonik NA1600.1AB Neuron Series Class A/B Monoblock 1600 Watts 4 Ohms Car Amplifier 

The NEURON Series of Amplifiers from Alphasonik will leave you astonished when you experience the power deliverance of these amplifiers and leave you in a conundrum on how it’s even possible to achieve the power vs the almighty dollar. Not only did we accomplish the power that is needed and desired. but we didn’t leave out any of the bells & whistles either. Things like 4-way protection circuitry and RCA throughputs to add more amplifiers.

• High-Level Inputs
  ???????High-Level Inputs are an added bonus of having the capability of using the source units speaker outputs. Having High Level Inputs is needed if your source unit doesn’t have Low-Level Outputs. Tap into the rear deck’s speakers and you’re all set! Eliminating the need for a Hi to Low Converter.
• Nickel Plated Terminal Block
  Nickel-plated terminal blocks have been used on the NEURON series amplifiers. Since most cable is stranded. it is necessary to use terminal blocks to hold the strands together in fastening the connections. This type of terminal block maximizes the connection to deliver the voltage and current draw needed.
• Extruded Heat Sink
  Keeping the amplifier cool increases the efficiency to an amplifier. To keep an amplifier cool is a combination of several things. but the most important two are power output and heatsink size. A heatsink size is not the only way to cool down an amplifier. Having increased the area of the heatsink increases the cooling dramatically. So. we extruded the heatsink so we can get the most advantageous area to aid the cooling efficiency.
• Remote Bass Knob
  External bass controller that will allow you to adjust the bass level remotely without having to retune the amplifier. This is a perfect solution to increase and decrease the bass when you have a wide variety of music genres. Giving you the ability to adjust the bass song by song.

• Specifications:

  • RMS 4 Ohms: 800 Watts x 1
  • RMS 2 Ohm: 1600 Watts x 1
  • Terminal: Nickel Plated
  • Input Signal: Low Level & High-Level Inputs
  • Output Signal: No
  • Remote Bass Knob: Yes
  • Amplifier Protection: Thermal. Short Circuit. Overload and DC Offset
  • Low Pass Crossover: 50 Hz – 250Hz
  • Variable Input Sensitivity: 200mV – 6V
  • Frequency Response: 10Hz – 250Hz
  • Bass Boost: 0 – 12dB
  • S/N Ratio: >90dB (+/-3dB)
  • Fuse Rating: ATC 30A x 2