Rockville KRYPTON S6 Marine/Boat 2600 Watt 6 Channel Amplifier + PA Microphone

All About Your KRYPTON S6:

Features:
Rockville KRYPTON S6 2600 Watt Peak/660 Watt RMS 6 Channel Class AB Marine Stereo Amplifier
Dyno certified RMS Power: (less than 1 % distortion) (Use these ratings when comparing with other premium brands such as Kicker. Rockford Fosgate. etc.)
2 Ohm: 110 Watts x 6 Channel <1% THD+N @ 14.4 Volts
4 Ohm: 75 Watts x 6 Channel <1% THD+N @ 14.4 Volts
4 Ohm Bridged: 220 Watts x 3 Channel <1% THD+N @ 14.4 Volts
Peak Power: (Use these ratings when comparing with great budget brands such as Boss. Power Acoustik. Crunch. etc.)
2 Ohm: 440 Watts x 6 Channel
4 Ohm: 300 Watts x 6 Channel
4 Ohm Bridged: 880 Watts x 3 Channel
Digital Voltage Display on Amp
Microphone input and PA microphone included
Adjustable Low Pass Filter: 40Hz – 4KHz
Adjustable High Pass Filter: 15Hz – 4KHz
Adjustable Band Pass Filter: 15Hz – 4KHz
Painted Conformal Coating PCB Board (Uses 2577 Waterproof Glue)
Rustproof Aluminum heat sink with black hairline finish
Stainless steel end panels are rustproof
All screws and mounting hardware are stainless steel and rustproof
Bottom panel is aluminum and rustproof
4 Gauge power and ground terminals
10 Guage speaker wire terminals
All channels on the amp have crossovers so they can each be used for subs or full range speakers or tweeters or midrange speakers
All channels on the amplifier are bridgeable
High-Speed MOSFET Power Supply
Under Voltage Protection at 10V
Over Voltage Protection at 16V
Tertiary Supplies Circuitry
Studio-Grade Bipolar Output Stage Transistors
Fully Adjustable 12dB / Octave Crossover with Differential Circuitry
Full IC-Controlled Protection Circuitry
Fully Adjustable 12dB Bass Equalizer
Adjustable Input Level Control
Mute and Delay Soft Start System
2CH/4CH/6CH Input Mode Switch
8 Volt Preamp Circuitry
Status Mode LED Indicator
Minimum THD at Rated Power: < 0.05%
S / N Ratio: >90dB
Frequency Response: 10Hz – 50KHz
Damping Factor: >85 @ 100Hz
30 Amp x 3 ATC Fuse
Dimensions: (W x H x L) 8.66 x 2.2 x 18.3

• What’s in the Box: Amplifier. Bass Remote. PA microphone. Birth sheet with Dyno-tested power. Mounting Screw Kit. Owner’s manual. Warranty. Instructions including installation video
• Features of Krypton S6: Rockville Krypton S6 2600 Watt Peak/660 Watt RMS 6 Channel Class AB Marine Stereo Amplifier. Dyno certified RMS Power: (less than 1 % distortion) (Use these ratings when comparing with other premium brands such as Kicker. Rockford Fosgate. etc.). 2 Ohm: 110 Watts x 6 Channel <1% THD+N @ 14.4 Volts. 4 Ohm: 75 Watts x 6 Channel <1% THD+N @ 14.4 Volts. 4 Ohm Bridged: 220 Watts x 3 Channel <1% THD+N @ 14.4 Volts.
• Peak Power: (Use these ratings when comparing with great budget brands such as Boss. Power Acoustik. Crunch. etc.). 2 Ohm: 440 Watts x 6 Channel. 4 Ohm: 300 Watts x 6 Channel. 4 Ohm Bridged: 880 Watts x 3 Channel. Digital Voltage Display on Amp. Microphone input and PA microphone included. Adjustable Low Pass Filter: 40Hz ?C 4KHz. Adjustable High Pass Filter: 15Hz ?C 4KHz.
• Adjustable Band Pass Filter: 15Hz ?C 4KHz. Painted Conformal Coating PCB Board (Uses 2577 Waterproof Glue). Rustproof Aluminum heat sink with black hairline finish. Stainless steel end panels are rustproof. All screws and mounting hardware are stainless steel and rustproof. Bottom panel is aluminum and rustproof. 4 Gauge power and ground terminals. 10 Guage speaker wire terminals.
• All channels on the amp have crossovers so they can each be used for subs or full range speakers or tweeters or midrange speakers. All channels on the amplifier are bridgeable. High-Speed MOSFET Power Supply. Under Voltage Protection at 10V. Over Voltage Protection at 16V. Tertiary Supplies Circuitry. Studio-Grade Bipolar Output Stage Transistors. Fully Adjustable 12dB / Octave Crossover with Differential Circuitry.